Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2006NAVIGATOR 4WD V8-5.4L VIN 5REPAIR AND DIAGNOSISBODY AND FRAMERELAYS AND MODULES - BODY AND FRAMEPOWER TRUNK / LIFTGATE CONTROL MODULESERVICE AND REPAIR
2006 Lincoln Navigator 4WD V8-5.4L VIN 5
Power Trunk / Liftgate Control Module: Service and Repair
2006 Lincoln Navigator 4WD V8-5.4L VIN 5SECTION Service and Repair
POWER LIFTGATE MODULE
Removal and Installation
NOTE: Prior to removal of the power liftgate module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new power liftgate module once installed.
1. Remove the rear quarter trim panel.
2. Remove the power liftgate module.
1 Disconnect the electrical connectors.
2 Remove the nut.
- To install, tighten to 11 Nm (8 lb-ft).
3. NOTE: Once the new power liftgate module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new power liftgate module.
To install, reverse the removal procedure.
Removal and Installation
NOTE: Prior to removal of the power liftgate module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new power liftgate module once installed.
1. Remove the rear quarter trim panel.
2. Remove the power liftgate module.
1 Disconnect the electrical connectors.
2 Remove the nut.
- To install, tighten to 11 Nm (8 lb-ft).
3. NOTE: Once the new power liftgate module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new power liftgate module.
To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.