Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2006NAVIGATOR 4WD V8-5.4L VIN 5REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTCOLLISION AVOIDANCE AND PARKING ASSIST SYSTEMSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSAZIMUTH SYSTEM CHECK
2006 Lincoln Navigator 4WD V8-5.4L VIN 5
Azimuth System Check
2006 Lincoln Navigator 4WD V8-5.4L VIN 5SECTION Azimuth System Check
AZIMUTH SYSTEM CHECK
1. NOTE:
- The detectable object used in this system check can be fabricated using a 7.62 cm (3 inches) diameter plastic pipe, 99.06 cm (39 inches) in length (available as PVC pipe, or similar from a hardware or plumbing supply).
- The following system check should be carried out with the vehicle on a level surface.
- The parking aid module system defaults to on when the ignition key is cycled from the OFF position to the ON position.
Turn the ignition to the ON position, engine off.
2. Set the parking brake on.
3. Place the gearshift in REVERSE (R).
4. Verify the parking aid module detects the object when it is placed within the 5 specified locations (P1, P2, P3, P4 and P5). These zones are shown ideally and are not absolute. The pipe should be inside of the locations.
Minimum Detectable Object Locations:
1. NOTE:
- The detectable object used in this system check can be fabricated using a 7.62 cm (3 inches) diameter plastic pipe, 99.06 cm (39 inches) in length (available as PVC pipe, or similar from a hardware or plumbing supply).
- The following system check should be carried out with the vehicle on a level surface.
- The parking aid module system defaults to on when the ignition key is cycled from the OFF position to the ON position.
Turn the ignition to the ON position, engine off.
2. Set the parking brake on.
3. Place the gearshift in REVERSE (R).
4. Verify the parking aid module detects the object when it is placed within the 5 specified locations (P1, P2, P3, P4 and P5). These zones are shown ideally and are not absolute. The pipe should be inside of the locations.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.