Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSLINCOLN2005LS 3.0 SREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1406 (ENGINE SYSTEM - GENERAL INFORMATION)GENERAL PROCEDURESVALVE SPRING SQUARENESS

2005 Lincoln LS 3.0 S

Valve Spring Squareness

2005 Lincoln LS 3.0 SSECTION Valve Spring Squareness

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Measure the out-of-square on each valve spring.
- Turn the valve spring and observe the space between the top of the valve spring and the square.

Fig 1: Measuring Valve Spring Out-Of-Square

Courtesy of FORD MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.