Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lincoln LS 3.0 S, AutomaticFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Battery Junction Box (BJB) | In Luggage Compartment, Right Of Battery |
| Data Link Connector (DLC) | Under Center Of Instrument Panel |
| Driver's Door Module (DDM) | Behind Center Of Driver's Door Panel |
| Front Electronic Module (FEM) | Behind Driver's Side Kick Panel |
| Instrument Panel Fuse Box | Under Instrument Panel, In Right Side Footwell |
| Rear Electronic Module (REM) | In Luggage Compartment, Right Side |
| Window Control Switch | Appropriate Door Panel Arm Rest |
| Window Motor | Behind Appropriate Door Panel |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.