Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2012IS 250C V6-2.5L (4GR-FSE)REPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLSERVICE PRECAUTIONS
2012 Lexus IS 250C V6-2.5L (4GR-FSE)
Brakes and Traction Control: Service Precautions
2012 Lexus IS 250C V6-2.5L (4GR-FSE)SECTION Service Precautions
BRAKE SYSTEM (OTHER): BRAKE SYSTEM: PRECAUTION
NOTICE:
* The vehicle is equipped with an SRS (Supplemental Restraint System). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident. Before servicing (including inspection, replacement, removal, and installation of parts), be sure to read the precautionary notices for the Supplemental Restraint System Service Precautions.
* Care must be taken to replace each part properly as it could affect the performance of the brake system and result in a driving hazard. Replace the parts with those having the same part number or equivalent.
* It is very important to keep parts and the area clean when repairing the brake system.
* If the vehicle is equipped with a mobile communication system, refer to Precaution in the INTRODUCTION section Service Precautions.
* Care must be taken when using magnets as they could affect the performance of the speed sensors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.