Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2010RX 450H 3.5 BREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXCRUISE CONTROL DTCSDYNAMIC RADAR CRUISE CONTROL SYSTEM (TO 08/2009)
2010 Lexus RX 450h 3.5 B
Dynamic Radar Cruise Control System (To 08/2009)
2010 Lexus RX 450h 3.5 BSECTION Dynamic Radar Cruise Control System (To 08/2009)
DYNAMIC RADAR CRUISE CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC Code | Description |
|---|---|
| C1A01 | Driving Support ECU |
| C1A02 | Vehicle Information Not Obtained |
| C1A03 | Driving Support ECU Internal Logical Error |
| C1A05 | Stop Light Switch Circuit |
| C1A06 | Stop Light Switch Input Circuit |
| C1A0A | Front Radar Sensor Region Code Mismatch |
| C1A10 | Front Radar Sensor |
| C1A11 | Front Radar Sensor Incorrect Axial Gap |
| C1A14 | Front Radar Sensor Beam Axis Not Adjusted |
| C1A40 | ENG / EHV Device |
| C1A41 | Brake Request Value Mismatch between ENG / EHV and Driving Support ECU |
| C1A4A | Skid Control Buzzer Circuit |
| C1A4B | Stop Light Relay Circuit |
| C1A50 | Brake System |
| P1615 | Communication Error from Distance Control ECU to HV ECU |
| U0122 | Lost Communication with Vehicle Dynamics Control Module |
| U0123 | Lost Communication with Yaw Rate Sensor Module |
| U0126 | Lost Communication with Steering Angle Sensor Module |
| U0235 | Lost Communication with Cruise Control Front Distance Range Sensor |
| U0293 | Lost Communication with HV ECU |
| U1104 | Lost Communication with Driving Support ECU |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.