Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2010RX 450H 3.5 BREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLBRAKE CONTROL (SERVICE INFORMATION)VSC OFF SWITCHINSTALLATION (TO 08/2009)INSTALLATION
2010 Lexus RX 450h 3.5 B
Installation (To 08/2009): Installation
2010 Lexus RX 450h 3.5 BSECTION Installation
- INSTALL VSC OFF SWITCH
- Engage the 2 claws and install the VSC OFF switch.
- INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 46
- INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY . Refer to INSTALLATION - Step 47
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- INSTALL REAR DECK FLOOR BOX . Refer to INSTALLATION - Step 69
- CHECK FOR WARNING LIGHT AND INDICATOR LIGHT
HINT:
Refer to TEST MODE PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.