Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSLEXUS2010RX 450H 3.5 BREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLBRAKE CONTROL (SERVICE INFORMATION)SKID CONTROL BUZZERINSTALLATION (TO 08/2009)INSTALLATION

2010 Lexus RX 450h 3.5 B

Installation (To 08/2009): Installation

2010 Lexus RX 450h 3.5 BSECTION Installation

INSTALL SKID CONTROL BUZZER ASSEMBLY
1. Connect the skid control buzzer connector.
  
  Fig 1: Connect the skid control buzzer connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the skid control buzzer clamp.
  
  Fig 2: Install the skid control buzzer clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
HINT:

Refer to the procedure up to Install Instrument Panel Junction Block Assembly. Refer to INSTALLATION - Step 2 .
INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT:

Refer to the procedure up to Install Driver Side Knee Airbag Assembly. Refer to INSTALLATION .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.