Removal (To 08/2009): Removal

HINT: 

• Use the same procedure for the LH side and RH side.
• The following procedure is for the LH side.
• If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.

1. PRECAUTION (w/ Navigation System for HDD) 
   NOTE:

   After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. PRECAUTION (w/ Air Suspension) 
   NOTE:

   Be sure to read Precaution thoroughly before servicing. Refer to PRECAUTION .

3. REMOVE REAR DECK FLOOR BOX  . Refer to REMOVAL - Step 2
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   NOTE:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

5. REMOVE FRONT WHEEL 
6. REMOVE FRONT SPEED SENSOR 
   1. Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.
      Fig 1: Turn The Pins 90 Degrees

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH side and LH side.

   2. Remove the 5 clips and 3 screws, and turn back the front fender liner.
      Fig 2: Remove the 5 clips and 3 screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Disconnect the front speed sensor connector and remove the 2 clamps.
      Fig 3: Identifying Front Speed Sensor Connector And Clamps

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the bolt and No. 2 sensor clamp from the body.
      Fig 4: Remove the bolt and No. 2 sensor clamp

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION
      
      

      *1	No. 2 Sensor Clamp

   5. Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the shock absorber assembly.
      Fig 5: Remove the bolt, No. 1 sensor clamp

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION
      
      

      *1	No. 1 Sensor Clamp
      *2	Front Brake Flexible Hose

   6. Remove the bolt, resin clamp and front speed sensor.
      Fig 6: Remove the bolt, resin clamp and front speed sensor

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION
      
      

      *1	Resin Clamp

      NOTE:

      • Prevent foreign matter from attaching to the front speed sensor tip.
      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.