Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC B2289: Key Collation Waiting Time Over: Procedure
- CHECK FOR DTC (EACH SYSTEM)
- Delete the DTCs.
HINT:
After all DTCs are cleared, check if the trouble occurs again 5 seconds after the power switch is turned ON (IG).
- Check for DTCs again.RESULT
Result Proceed to DTC is not output A DTC is output B HINT:
"Each system" means the smart access system and engine immobilizer system.
B → GO TO DTC CHART
A → GO TO SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Door Lock)
- Delete the DTCs.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.