Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code Chart
- CERTIFICATION ECU DTC CHART
HINT:
If a trouble code is displayed during the DTC check, check the circuit listed for that code in the table below. Then proceed to the appropriate article.
CERTIFICATION ECU:DTC Code Detection Item Trouble Area See B2784 Antenna Coil Open / Short - Certification ECU
- Power switchRefer to DTC B2784: Antenna Coil Open / Short B2785 Communication Malfunction between ECUs Connected by LIN - Wire harness
- Certification ECU
- Power source control ECU
- Steering lock actuator (steering lock ECU)
- ID code boxRefer to DTC B2785: Communication Malfunction between ECUs Connected by LIN B2786 No Response from Steering Lock ECU - Wire harness
- Certification ECU
- Steering actuator (steering lock ECU)Refer to DTC B2786: No Response from Steering Lock ECU B2789 No Response from ID BOX - Wire harness
- ID code box
- Certification ECURefer to DTC B2789: No Response from ID BOX B278A Short to GND in Immobilizer System Power Source Circuit - Wire harness
- Power switch
- Certification ECURefer to DTC B278A: Short to GND in Immobilizer System Power Source Circuit B2790 ID BOX EEPROM Malfunction ID code box Refer to DTC B2790: ID BOX EEPROM Malfunction - HYBRID VEHICLE CONTROL ECU DTC CHART
HINT:
The DTCs for the immobilizer system are specified above. If other codes are output, check the DTC chart for the hybrid control system.
HYBRID VEHICLE CONTROL ECU:DTC Code Detection Item Trouble Area See B2799-542 Engine Immobilizer System Malfunction - Wire harness
- ID code box
- Hybrid vehicle control ECURefer to DTC B2799-542: Engine Immobilizer System Malfunction; DTC B2799-790: Engine Immobilizer System Malfunction B2799-790 Engine Immobilizer System Malfunction - Wire harness
- ID code box
- Hybrid vehicle control ECURefer to DTC B2799-542: Engine Immobilizer System Malfunction; DTC B2799-790: Engine Immobilizer System Malfunction
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.