2008 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Inspection Procedure

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK IMAGE QUALITY SETTING 
    1. Enter the display adjustment screen by pressing the "DISPLAY" switch.
      Fig 1: Pressing Display Switch
      G05293263Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the light control switch to TAIL.
    3. Check if "DAY MODE" on the display adjustment is ON.

      OK: 

      "DAY MODE" is ON. 

    OK: TURN FORCED "DAY MODE" SETTING OFF 

    NG: Go to next step 

  2. CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE) 
    1. Enter the Display Check mode's Vehicle Signal Check Mode (see DISPLAY CHECK MODE  ).
      Fig 2: Diagnostic Tool Display - Vehicle Signal Check Mode
      G05293264Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the light control switch to TAIL, ON and OFF.
      LIGHT CONTROL SWITCH REFERENCE CHART

      Light Control Switch Display
      TAIL or ON ON
      OFF OFF

      HINT:

      The display is updated once per second. It is normal for the display to lag behind the actual switch operation.

    NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

    OK: REPLACE MULTI-DISPLAY 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.