Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
- VEHICLE BROUGHT TO WORKSHOPÂ
- INSPECT BATTERY VOLTAGEÂ
Standard Voltage: 11 to 14 VÂ
If the voltage is below 11V, recharge or replace the battery before proceeding
- BASIC INSPECTIONÂ
- Turn the engine switch on (IG).
- Check whether or not the radio receiver turns on.
ResultÂ
RESULT REFERENCEResult Proceed to Radio receiver turns on A Radio receiver does not turn on B
B: Go to step  6
A: Go to next stepÂ
- CHECK FOR DTCÂ
- Check for DTCs and note any codes that are output.
- Clear the DTCs
- Recheck for DTCs by simulating the operation indicated by the DTCs.
HINT.
- If the system cannot enter the diagnosis mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part
- Even if the malfunction symptom is not confirmed, check for DTCs This is because the system stores past DTCs
- Check and clear the past DTCs. Then check for DTCs
ResultÂ
RESULT REFERENCEResult Proceed to DTC is output again A DTC is not output B
B: Go to step  6
A: Go to next stepÂ
- DIAGNOSTIC TROUBLE CODE CHARTÂ
Find the output code on Diagnostic Trouble Code Chart (See DIAGNOSTIC TROUBLE CODE CHARTÂ )
NEXT: Go to step  8
- PROBLEM SYMPTOMS TABLEÂ
Refer to PROBLEM SYMPTOMS TABLEÂ
ResultÂ
RESULT REFERENCEResult Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B B: Go to step  8
A: Go to next stepÂ
- OVERALL ANALYSIS AND TROUBLESHOOTINGÂ
- Terminals of ECU (See TERMINALS OF ECUÂ )
- ADJUST, REPAIR OR REPLACEÂ
- CONFIRMATION TESTÂ
NEXT: ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
