Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:
- Use these procedures to troubleshoot the smart access system with push-button start.
- *: Use Techstream.
- VEHICLE BROUGHT TO WORKSHOPÂ
- INSPECT BATTERY VOLTAGEÂ
Standard voltage:Â
11 to 14 VÂ
If the voltage is below 11 V, recharge or replace the battery before proceeding.
- INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)*Â
- Use Techstream to check if the Multiplex Communication System (MPX) is functioning normally.
ResultÂ
RESULT REFERENCE CHARTResult Proceed to MPX DTC is not output A MPX DTC is output B
B:Â GO TO MULTIPLEX COMMUNICATION SYSTEM
A: Go to Next StepÂ
- Use Techstream to check if the Multiplex Communication System (MPX) is functioning normally.
- CHECK FOR DTC*Â
- Check for DTC and note any codes that are output.
- Delete DTC.
- Recheck DTC.
ResultÂ
RESULT REFERENCE CHARTResult Proceed to DTC does not reoccur A DTC reoccurs B
B:Â GO TO DIAGNOSTIC TROUBLE CODE CHARTÂ
A: Go to Next StepÂ
- PROBLEM SYMPTOMS TABLEÂ
ResultÂ
RESULT REFERENCE CHARTResult Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B B: Go to step  7
A: Go to Next StepÂ
- OVERALL ANALYSIS AND TROUBLESHOOTING*Â
- Terminals of ECU (See TERMINALS OF ECUÂ )
- DATA LIST/ACTIVE TEST (See DATA LIST / ACTIVE TESTÂ )
- REPAIR OR REPLACEÂ
- CONFIRMATION TESTÂ
NEXT: ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
