2008 Lexus GS 450hFACTORY OEM SERVICE PROCEDURE

Diagnostic Trouble Code Chart

Push-button start 

DIAGNOSTIC TROUBLE CODE CHART

DTC No. Detection Item Trouble Area
B2271  Ignition Hold Monitor Malfunction
  • Power source control ECU
  • AM2 fuse
  • Wire harness
B2272  Ignition 1 Monitor Malfunction
  • Power source control ECU
  • Wire harness
B2273  Ignition 2 Monitor Malfunction
  • Power source control ECU
  • IG2 relay
  • Wire harness
B2274  ACC Monitor Malfunction
  • Power source control ECU
  • Wire harness
B2275  STSW Monitor Malfunction
  • Power source control ECU
  • Hybrid control system
  • Wire harness
B2277  Detecting Vehicle Submersion Power source control ECU
B2278  Power Switch Circuit Malfunction
  • Power source control ECU
  • Power switch
  • Wire harness
B2281  "P" Signal Malfunction
  • Power source control ECU
  • Shift lock system
  • Wire harness
B2282  Vehicle Speed Signal Malfunction
  • Power source control ECU
  • Combination meter
  • Wire harness
B2283  Vehicle Speed Sensor Malfunction
  • Power source control ECU
  • Combination meter
  • Speed sensor
  • Skid control ECU
  • Wire harness
B2284  Brake Signal Malfunction
  • Power source control ECU
  • Stop light switch
  • Lighting system
  • Wire harness
B2285  Steering Lock Position Signal Circuit Malfunction
  • Power source control ECU
  • Electric steering lock
  • Wire harness
B2286  Runnable Signal Malfunction
  • Power source control ECU
  • Hybrid control system
  • Wire harness
B2287  LIN Communication Master Malfunction
  • Power source control ECU
  • Certification ECU
  • Wire harness
B2288  Steering Lock Signal Circuit Malfunction
  • Power source control ECU
  • Electric steering lock
  • Wire harness
B2289  Key Collation Waiting Time Over
  • Power source control ECU
  • Entry function
  • Engine immobilizer system
  • Power switch
  • Key
  • Wire harness
NOTE:
  • Check the connector connection to the terminal to make sure that there is no abnormally such as a loose connection, deformations, etc.
  • Make sure that the power supply to the ECU and connection of the body ground are normal (DTC B2271 is not output).
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.