Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Lexus RX 350 FWDFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Installation

INSTALL CRANKSHAFT POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
2. Install the crankshaft position sensor with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
3. Connect the crankshaft position sensor connector.
INSTALL COMPRESSOR AND MAGNETIC CLUTCH
HINT:

(See INSTALLATION )
INSTALL GENERATOR ASSEMBLY
HINT:

(See INSTALLATION )

Fig 1: Identifying Crankshaft Position Sensor Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.