Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Oil Replacement Reminder Reset - Procedure 03
2007 Lexus ES 350SECTION Engine Oil Replacement Reminder Reset - Procedure 03
To reset OIL MAINT REQD reminder light after engine oil change:
- Turn ignition ON, with engine OFF.
- Push the ODO TRIP switch in the switch box (box flips out on left side of instrument panel) to change the display to blank.
- Turn ignition switch OFF.
- Hold down trip meter RESET switch and then turn ignition switch ON.
- Hold down the RESET switch for more than 7 seconds after ignition switch has been turned ON.
- The master warning light should come ON, a warning tone should sound, and the multi-information display will show a message informing that engine oil maintenance data has been reset.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.