Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2007ES 350REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROLMILLIMETER WAVE RADAR SENSORREMOVAL
2007 Lexus ES 350
Millimeter Wave Radar Sensor: Removal
2007 Lexus ES 350SECTION Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See AIRBAG SYSTEM ).
- REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
- REMOVE FRONT BUMPER ASSEMBLY (See DISASSEMBLY )
- REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
- Disconnect the connector.
- Remove the 3 bolts and the millimeter wave radar sensor assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.