Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSLEXUS2007ES 350REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESPARKING BRAKE SYSTEMPARKING BRAKEPARKING BRAKE CABLEINSTALLATION

2007 Lexus ES 350

Parking Brake Cable: Installation

2007 Lexus ES 350SECTION Installation

INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
1. Install the parking brake cable clamp to the No. 3 parking brake cable assembly.
2. Install the No. 3 parking brake cable assembly with 3 bolts (A), bolt (B) and nut (C), and engage each claw.
  Torque: Bolt (A) 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  Bolt (B) and Nut (C) 6.0 N*m (61 kgf*cm, 53 in.*lbf)
  
  Fig 1: Removing Parking Brake Cable Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.