SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2007ES 350REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTINGCONSOLE BOX LIGHTINSPECTION
2007 Lexus ES 350

Console Box Light: Inspection

2007 Lexus ES 350SECTION Inspection
  1. INSPECT CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY 
    1. Disconnect the F1 console box illumination light assembly connector.
    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      F1-2 - F1-1 Light control switch in TAIL 10 to 14 V
      J46-2 - J46-1 Light control switch OFF Below 1 V
      Fig 1: Identifying F1 Console Box Illumination Light Assembly Connector Terminals
      G05252489Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, there is a malfunction on the wire harness side.

    3. Apply battery voltage to the console box illumination light assembly connector.
    4. Check that the console box illumination light comes on.

      OK 

      MEASUREMENT CONDITION

      Measurement Condition Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1      		 Console box illumination light comes on

      If the result is not as specified, replace the console box illumination light assembly.

      Fig 2: Identifying F1 Console Box Illumination Light Assembly Connector Terminals (Components Side)
      G05252490Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.