Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cruise Control Main Switch: Installation
2007 Lexus ES 350SECTION Installation
- INSTALL CRUISE CONTROL MAIN SWITCH
- Install the cruise control main switch with the 2 screws.
Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
- Connect the connector.
- Install the cruise control main switch with the 2 screws.
- INSTALL STEERING PAD (See INSTALLATION )
- INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
- INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- INSPECT STEERING PAD (See INSTALLATION )
- INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )
- PERFORM INITIALIZATION NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.