Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2006RX 400H AWD V6-3.3L (3MZ-FE) HYBRIDREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSPOWER WINDOW REGULATOR MOTOR INSPECTION
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) Hybrid
Power Window Regulator Motor Inspection
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) HybridSECTION Power Window Regulator Motor Inspection
POWER WINDOW REGULATOR MOTOR
INSPECTION
1. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT RH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
2. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT LH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
3. INSPECT POWER WINDOW REGULATOR MOTOR (REAR RH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
4. INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
INSPECTION
1. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT RH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
2. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT LH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
3. INSPECT POWER WINDOW REGULATOR MOTOR (REAR RH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
4. INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH)
a. Remove the power window regulator motor.
b. Apply battery voltage to the motor connector according to the table given.
NOTE: Do not apply battery to any terminals except terminals 1 and 2.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.