Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2006RX 400H AWD V6-3.3L (3MZ-FE) HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESDATA LIST / ACTIVE TESTDATA LIST
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) Hybrid
Data List
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) HybridSECTION Data List
DATA LIST
HINT: By reading the DATA LIST displayed on an intelligent tester, you can check values, including those of the switches, sensors, and actuators, without removing any parts. Reading the DATA LIST as the first step of troubleshooting is one method of shortening diagnostic time.
NOTE: In the table given, the values listed under Normal Condition are reference only. Do not depend solely on these values when determining whether or not a part is faulty.
a. Put the engine in inspection mode.
b. Warm up the engine.
c. Turn the ignition switch off.
d. Connect the intelligent tester to the DLC3.
e. Turn the ignition switch ON.
f. Turn the tester ON.
g. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST.
h. Check the values by referring to the table given.
HINT: *1: If no idling conditions are specified, the transmission gear selector lever should be in the N or P position, and the A/C switch and all accessory switches should be OFF.
HINT: By reading the DATA LIST displayed on an intelligent tester, you can check values, including those of the switches, sensors, and actuators, without removing any parts. Reading the DATA LIST as the first step of troubleshooting is one method of shortening diagnostic time.
NOTE: In the table given, the values listed under Normal Condition are reference only. Do not depend solely on these values when determining whether or not a part is faulty.
a. Put the engine in inspection mode.
b. Warm up the engine.
c. Turn the ignition switch off.
d. Connect the intelligent tester to the DLC3.
e. Turn the ignition switch ON.
f. Turn the tester ON.
g. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST.
Part 1:
Part 2:
Part 3:
Part 4:
Part 5:
Part 6:
Part 7:
h. Check the values by referring to the table given.
HINT: *1: If no idling conditions are specified, the transmission gear selector lever should be in the N or P position, and the A/C switch and all accessory switches should be OFF.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.