Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2006RX 400H AWD V6-3.3L (3MZ-FE) HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSENSORS AND SWITCHES - COMPUTERS AND CONTROL SYSTEMSACCELERATOR PEDAL POSITION SENSORSERVICE AND REPAIR
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) Hybrid
Accelerator Pedal Position Sensor: Service and Repair
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) HybridSECTION Service and Repair
REMOVAL
REMOVE ACCELERATOR PEDAL ROD ASSEMBLY
a. Disconnect the connector from the accelerator pedal rod assembly.
b. Remove the 2 nuts and accelerator pedal rod assembly.
INSTALLATION
INSTALL ACCELERATOR PEDAL ROD ASSEMBLY
a. Install the accelerator pedal rod assembly with the 2 nuts.
Torque: 4.9 N.m (50 kgf.cm, 43 in.lbf)
b. Connect the connector to the accelerator pedal rod assembly.
REMOVE ACCELERATOR PEDAL ROD ASSEMBLY
a. Disconnect the connector from the accelerator pedal rod assembly.
b. Remove the 2 nuts and accelerator pedal rod assembly.
INSTALLATION
INSTALL ACCELERATOR PEDAL ROD ASSEMBLY
a. Install the accelerator pedal rod assembly with the 2 nuts.
Torque: 4.9 N.m (50 kgf.cm, 43 in.lbf)
b. Connect the connector to the accelerator pedal rod assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.