Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2006RX 400H AWD V6-3.3L (3MZ-FE) HYBRIDREPAIR AND DIAGNOSISHYBRID DRIVE SYSTEMSPOWER CONTROL SYSTEMDRIVE MOTOR CIRCUIT BREAKER SENSORSERVICE AND REPAIRFRONT CIRCUIT BREAKER SENSOR
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) Hybrid
Front Circuit Breaker Sensor
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) HybridSECTION Front Circuit Breaker Sensor
REMOVAL
1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL
2. REMOVE ENGINE ROOM SIDE LH COVER
3. REMOVE AIR CLEANER CAP W/INLET
4. REMOVE CIRCUIT BREAKER SENSOR NO.1
a. Move the outer section to the wire harness side as illustrated, then disconnect the circuit breaker sensor No.1.
b. Remove the 2 bolts and circuit breaker sensor No.1from the w/ converter inverter assembly.
INSTALLATION
1. INSTALL CIRCUIT BREAKER SENSOR NO.1
a. Install the circuit breaker sensor No.1 with the 2bolts to the w/ converter inverter assembly.
Torque: 8.0 N.m (82 kgf.cm, 70 in.lbf)
b. Connect the connector to the circuit breaker sensor No.1.
2. INSTALL AIR CLEANER CAP W/INLET
3. INSTALL ENGINE ROOM SIDE LH COVER
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
Some system need initialization when reconnecting the battery cable.
1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL
2. REMOVE ENGINE ROOM SIDE LH COVER
3. REMOVE AIR CLEANER CAP W/INLET
4. REMOVE CIRCUIT BREAKER SENSOR NO.1
a. Move the outer section to the wire harness side as illustrated, then disconnect the circuit breaker sensor No.1.
b. Remove the 2 bolts and circuit breaker sensor No.1from the w/ converter inverter assembly.
INSTALLATION
1. INSTALL CIRCUIT BREAKER SENSOR NO.1
a. Install the circuit breaker sensor No.1 with the 2bolts to the w/ converter inverter assembly.
Torque: 8.0 N.m (82 kgf.cm, 70 in.lbf)
b. Connect the connector to the circuit breaker sensor No.1.
2. INSTALL AIR CLEANER CAP W/INLET
3. INSTALL ENGINE ROOM SIDE LH COVER
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
Some system need initialization when reconnecting the battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.