Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2006RX 400H AWD V6-3.3L (3MZ-FE) HYBRIDREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRREMOVAL AND INSTALLATION
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) Hybrid
Removal and Installation
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) HybridSECTION Removal and Installation
REMOVAL
1. REMOVE CONSOLE PANEL UPPER FRONT
2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER
3. REMOVE RADIO AND RECEIVER ASSEMBLY WITH BRACKET
4. REMOVE CENTER CLUSTER INTEGRATION SWITCH
a. Remove the 2 bolts.
b. Release the 6 clips.
c. Disconnect the connector and remove center cluster integration switch.
INSTALLATION
1. INSTALL CENTER CLUSTER INTEGRATION SWITCH
a. Install the connector.
b. Install the center cluster integration switch with the 2 bolts.
2. INSTALL RADIO AND RECEIVER ASSEMBLY WITH BRACKET
3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER
4. INSTALL CONSOLE PANEL UPPER FRONT
1. REMOVE CONSOLE PANEL UPPER FRONT
2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER
3. REMOVE RADIO AND RECEIVER ASSEMBLY WITH BRACKET
4. REMOVE CENTER CLUSTER INTEGRATION SWITCH
a. Remove the 2 bolts.
b. Release the 6 clips.
c. Disconnect the connector and remove center cluster integration switch.
INSTALLATION
1. INSTALL CENTER CLUSTER INTEGRATION SWITCH
a. Install the connector.
b. Install the center cluster integration switch with the 2 bolts.
2. INSTALL RADIO AND RECEIVER ASSEMBLY WITH BRACKET
3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER
4. INSTALL CONSOLE PANEL UPPER FRONT
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.