Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2006RX 400H AWD V6-3.3L (3MZ-FE) HYBRIDREPAIR AND DIAGNOSISBODY AND FRAMEDESCRIPTION AND OPERATIONRUST RESISTANT BODY
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) Hybrid
Rust Resistant Body
2006 Lexus RX 400h AWD V6-3.3L (3MZ-FE) HybridSECTION Rust Resistant Body
Rust-Resistant Body
1. General
Rust-resistant performance is enhanced extensive use of anti-corrosion sheet steel, as well as by an anti-corrosion treatment which includes the application of anti-rust wax, sealer and anti-chipping paint to easily corroded parts such as the hood, doors and rocker panels.
2. Anti-Corrosion Sheet Steel
Anti-corrosion sheet steel is used in all areas other than the roof and interior parts.
3. Wax and Sealer
Wax and sealer are applied to hemmed portions of the hood, door panels, rocker panels, and back door to improve rust-resistant performance.
4. Under Coat
Acrylic acid resin is applied to under side of the body, inside the rear wheel housing and other parts that are susceptible to stone chipping damage, thus improving the rust-resistant performance of there areas.
5. Anti-Chipping Application
Anti-chipping paint has been applied around the wheel housing. In addition, soft-chip primer has been applied to the front end of the hood. Furthermore, a large rocker molding is used on all models as standard equipment in order to ensure chip resistance performance in the rocker panel area.
1. General
Rust-resistant performance is enhanced extensive use of anti-corrosion sheet steel, as well as by an anti-corrosion treatment which includes the application of anti-rust wax, sealer and anti-chipping paint to easily corroded parts such as the hood, doors and rocker panels.
2. Anti-Corrosion Sheet Steel
Anti-corrosion sheet steel is used in all areas other than the roof and interior parts.
3. Wax and Sealer
Wax and sealer are applied to hemmed portions of the hood, door panels, rocker panels, and back door to improve rust-resistant performance.
4. Under Coat
Acrylic acid resin is applied to under side of the body, inside the rear wheel housing and other parts that are susceptible to stone chipping damage, thus improving the rust-resistant performance of there areas.
5. Anti-Chipping Application
Anti-chipping paint has been applied around the wheel housing. In addition, soft-chip primer has been applied to the front end of the hood. Furthermore, a large rocker molding is used on all models as standard equipment in order to ensure chip resistance performance in the rocker panel area.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.