Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Laser Sensor: Replacement
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE FRONT FENDER LINER LH (See REPLACEMENT )
- REMOVE FRONT FENDER LINER RH (See REPLACEMENT )
- REMOVE FRONT BUMPER COVER (See REPLACEMENT )
- REMOVE FRONT BUMPER ENERGY ABSORBER (See REPLACEMENT )
- REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSY (See REPLACEMENT )
- REMOVE LASER SENSOR
- Disconnect the connector and remove the laser sensor.
- INSTALL LASER SENSOR NOTE: Do not install the laser sensor if it has been damaged or received some sort of shock.
- INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSY (See REPLACEMENT )
- ADJUST LASER SENSOR (See ADJUSTMENT
)
SST 09870-60000 (09870-60010, 09870-60020)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
