Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE
Laser Sensor: Adjustment
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not stare at the luminous portion of the laser during adjustment. The intensity of the laser light is low, but it may result in loss of sight.
- If operation is not carried out as specified, there may be a risk that you are exposed to hazardous radiation.
HINT:
- When replacing the ECM of the vehicle with Laser Cruise Control with a new one, perform procedure 1 to 5 in step ( c) so that the ECM recognizes that the vehicle is equipped with Laser Cruise Control
- There is a limitation on laser beam axis adjustment.
- Since the laser sensor is installed in the bumper reinforcement, it is important that the laser sensor, bumper reinforcement, etc. are installed properly.
- When the sensor is removed from the vehicle for trouble diagnosis or repair, it is necessary to adjust the laser beam axis after the operation.
- ADJUST LASER SENSOR NOTE:
- Perform measurement indoors on a level ground and in front of a blank wall. Park the vehicle at least 9 m (29.53 ft) from the wall. When performing adjustment outdoors, make sure that it is not raining or snowing.
- Check that there are no reflective materials in the surroundings or on the ground.
- If you can not secure a distance of about 9 m (29.53 ft) in front of the vehicle, be sure to secure at least 7 m (22.97 ft) from the vehicle, and cover the area marked [A] with a black cloth. If not covered with a black cloth, the laser sensor may detect something other than the target and it will fail to adjust properly.
- Preparation for adjusting the laser beam axis
- Adjust the tires pressure properly. (See WHEEL AND TIRE SYSTEM )
- Luggage in the vehicle such as in the trunk should be unloaded.
- Clean the light-luminous and light-receiving portions of the laser sensor.
- Prepare a 10 m (32.81 ft) string, a string with a sharp-pointed weight, and a 5 m (16.41 ft) tape measure.
- Reflector (SST) placement
- Measure the height to the center of the laser luminous portion.
- Adjust the center height of the reflector 48 mm (1.89 in.) higher than the center of the luminous portion.
SST 09870-60000 (09870-60010, 09870-60020)
NOTE: Adjust it as precise as possible.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
