2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE

Inspection Procedure

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER WINDOW LOCK SWITCH 
    1. Push the window lock switch OFF (normal) and check that the remote UP/DOWN function operates.
    Fig 1: Checking Power Window Lock Switch
    G02630538Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. OK: END 
    2. NG: GO TO NEXT STEP 
  2. CHECK MANUAL UP/DOWN FUNCTION 
    1. Check that the passenger side door window and slide door windows can be operated via each regulator switch.
    1. NG: OTHER PROBLEM (See  PROBLEM SYMPTOMS TABLE  ) 
    2. OK: GO TO NEXT STEP 
  3. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSY 

    HINT:

    Inspect the switch with the non-operational remote function.

    1. Remove the master switch.
    2. Check the resistance between the terminals of the master switch when each switch is operated, as shown in PASSENGER SIDE SWITCH SPECIFICATIONS .
    Fig 2: Checking Resistance Between Terminals Of Master Switch When Each Switch Is Operated
    G02630539Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Standard: 

    Passenger side switch 

    PASSENGER SIDE SWITCH SPECIFICATIONS

    Window Lock Switch Power Window Switch Terminal No. Specified Condition
    OFF (Normal) UP 1 - 15, 6 - 13 Below 1 Ω
    OFF 1 - 13 - 15
    DOWN 1 - 13, 6 - 15
    ON (Lock) UP 6 - 13
    OFF 13 - 15
    DOWN 6 - 15

    Rear LH switch 

    REAR LH SWITCH SPECIFICATIONS

    Window Lock Switch Power Window Switch Terminal No. Specified Condition
    OFF (Normal) UP 1 - 10, 6 - 12 Below 1 Ω
    OFF 1 - 10 - 12
    DOWN 1 - 12, 6 - 10
    ON (Lock) UP 6 - 12
    OFF 10 - 12
    DOWN 6 - 10

    Rear RH switch 

    REAR RH SWITCH SPECIFICATIONS

    Window Lock Switch Power Window Switch Terminal No. Specified Condition
    OFF (Normal) UP 1 - 16, 6 - 18 Below 1 Ω
    OFF 1 - 6 - 18
    DOWN 1 - 18, 6 - 16
    ON (Lock) UP 6 - 18
    OFF 16 - 18
    DOWN 6 - 16
    1. NG: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSY 
    2. OK: REPAIR OR REPLACE HARNESS AND CONNECTOR (MASTER SWITCH - EACH REGULATOR SWITCH) 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.