2005 Lexus ES 330FACTORY OEM SERVICE PROCEDURE

Problem Symptoms Table

WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
PROBLEM SYMPTOMS TABLE - POWER WINDOW CONTROL SYSTEM

Symptoms Suspected Area
AUTO UP/DOWN function does not operate
  1. Power window regulator motor assy (Driver side)
  2. Wire harness
  3. Power window regulator master switch assy
Remote UP/DOWN function does not operate
  1. Power window regulator motor assy (Driver side)
  2. Power window regulator master switch assy
  3. Wire harness
Manual UP/DOWN function does not operate (Driver side)
  1. P/W fuse
  2. Power window regulator master switch assy
  3. Power window regulator motor assy (Driver side)
  4. Wire harness
Manual UP/DOWN function does not operate (Passenger side)
  1. Power window regulator switch assy (Passenger side)
  2. Power window regulator motor assy (Passenger side)
  3. Wire harness
Manual UP/DOWN function does not operate (Rear LH)
  1. Power window regulator switch assy rear (Rear LH)
  2. Power window regulator motor assy LH (Rear LH)
  3. Wire harness
Manual UP/DOWN function does not operate (Rear RH)
  1. Power window regulator switch assy rear (Rear RH)
  2. Power window regulator motor assy RH (Rear RH)
  3. Wire harness
Power windows do not operate at all
  1. PWR fuse
  2. ECU-IG fuse
  3. P/W relay
  4. IG1 relay
  5. Power window regulator master switch assy
  6. Wire harness
  7. Instrument panel J/B assy (Multiplex network body ECU)
Power window can be operated after ignition switch is turned OFF even if operative conditions are not fulfilled
  1. Front door courtesy lamp switch
  2. Wire harness
  3. Multiplex network body ECU
Power window can be operated by wireless operation
  1. Multiplex network body ECU
AUTO UP operation does not fully close power window (Jam protection function is activated)
  1. Front door glass run LH
  2. Front door window glass LH
  3. Front door window regulator sub-assy LH
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.