Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wheel Alignment
2005 Lexus ES 330SECTION Wheel Alignment
NOTE:
Wheel alignment is defined as the measurement, analysis, and adjustment of steering and suspension angles to conform to manufacturer specifications. These angles usually include, but are not limited to: caster, camber, toe, and thrust angle. Where these angles are not adjustable and not in specification, component replacement or correction kits may be required. Errors in set-back and steering axis inclination (SAI) are often attributable to failed or damaged components and must be corrected prior to performing an alignment. Failure to replace or correct suggested parts or service may prevent a proper alignment. Before performing an alignment check, inspect and verify the following: Tire pressure and size . Vehicle loading . Ride height . Steering and suspension parts only if the inspection reveals that all the above are within published specifications, a wheel alignment check and a proper wheel alignment, if needed, may be performed. Under no circumstances should a technician bend or heat any steering or suspension component, unless specified by the vehicle manufacturer. All measurements and specifications must be noted on the inspection report.
| Condition | Code | Procedure |
|---|---|---|
| Beyond manufacturer's service interval | 3 | Suggest alignment check |
| Dog tracking, shown to be caused by faulty alignment | 2 | Suggest repair |
| Drift, shown to be caused by faulty alignment | A | Require alignment |
| Lead, shown to be caused by faulty alignment | A | Require alignment |
| Outside manufacturer's specifications | B | Require repair |
| Part has been changed, affecting alignment | A | Require alignment check |
| Pull, shown to be caused by faulty alignment | A | Require alignment |
| Steering wheel off-center | 2 | Suggest alignment |
| Tire wear, shown to be caused by faulty alignment | A | Require alignment |
| Wander, shown to be caused by faulty alignment | A | Require alignment |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.