SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2005ES 330REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROLREPLACEMENT
2005 Lexus ES 330

Cruise Control: Replacement

2005 Lexus ES 330SECTION Replacement

HINT:

Installation is in the reverse order of removal.

  1. DISCONNECT BATTERY NEGATIVE TERMINAL (SEE  SUPPLEMENTAL RESTRAINT SYSTEM  ) 
  2. REMOVE STEERING WHEEL COVER LOWER NO.2 (SEE  OVERHAUL  ) 
  3. REMOVE STEERING WHEEL COVER LOWER NO.3 (SEE  OVERHAUL  ) 
  4. REMOVE HORN BUTTON ASSY (SEE  REPLACEMENT  ) 
  5. REMOVE CRUISE CONTROL MAIN SWITCH ASSY 
    1. Disconnect the connector.
    2. Remove the 2 screws.
      Fig 1: Removing Cruise Control Main Switch Assembly Screws
      G02936432Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull out the cruise control main switch assy in the direction shown by the arrow in the illustration.
      Fig 2: Removing Cruise Control Main Switch Assembly
      G02936433Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL CRUISE CONTROL MAIN SWITCH ASSY 
    1. Install the cruise control main switch assy with the 2 screws.
      1. Torque: 2.35 N.m (24 kgf.cm, 21 in..lbf) 
    2. Connect the connector.
  7. INSTALL HORN BUTTON ASSY (SEE  REPLACEMENT  ) 
  8. INSPECT HORN BUTTON ASSY (SEE  ON-VEHICLE INSPECTION  ) 
  9. CONNECT BATTERY NEGATIVE TERMINAL 
  10. INSPECT SRS WARNING LIGHT (SEE  DIAGNOSIS SYSTEM  ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.