Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2004LX 470 V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISMAINTENANCEWHEELS AND TIRESWHEEL STUD / LUG NUTSERVICE AND REPAIRFRONT
2004 Lexus LX 470 V8-4.7L (2UZ-FE)
Front
2004 Lexus LX 470 V8-4.7L (2UZ-FE)SECTION Front
REPLACEMENT
1. REMOVE FRONT AXLE HUB
2. REMOVE HUB BOLT
a. Mount the axle hub with the disc in a soft jaw vice.
NOTICE: Close vice until it holds disc, do not tighten further.
b. Place matchmarks on the axle hub and disc.
c. Remove the 5 bolts and separate the axle hub from the disc.
d. Using a press, remove the hub bolt.
3. INSTALL HUB BOLT
a. Using an extension bar and press, install a new hub bolt.
b. Align the matchmarks and install the axle hub to the disc, and install the 5 bolts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)
4. INSTALL FRONT AXLE HUB
1. REMOVE FRONT AXLE HUB
2. REMOVE HUB BOLT
a. Mount the axle hub with the disc in a soft jaw vice.
NOTICE: Close vice until it holds disc, do not tighten further.
b. Place matchmarks on the axle hub and disc.
c. Remove the 5 bolts and separate the axle hub from the disc.
d. Using a press, remove the hub bolt.
3. INSTALL HUB BOLT
a. Using an extension bar and press, install a new hub bolt.
b. Align the matchmarks and install the axle hub to the disc, and install the 5 bolts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)
4. INSTALL FRONT AXLE HUB
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.