Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2004LX 470 V8-4.7L (2UZ-FE)REPAIR AND DIAGNOSISBODY AND FRAMEROOF AND ASSOCIATED COMPONENTSSUNROOF / MOONROOFADJUSTMENTS
2004 Lexus LX 470 V8-4.7L (2UZ-FE)
Sunroof / Moonroof: Adjustments
2004 Lexus LX 470 V8-4.7L (2UZ-FE)SECTION Adjustments
ADJUSTMENT
1. REMOVE SIDE GARNISH
Before making adjustment, using a screwdriver, remove the side garnishes.
HINT:
- Tape the screwdriver tip before use.
- After adjustment, reinstall the side garnishes.
2. ADJUST SLIDING ROOF GLASS FORWARD/REARWARD AND LEFT/RIGHT DIRECTIONS
a. Loosen the sliding roof glass installation nuts.
b. Adjust the sliding roof glass forward/rearward or left/right.
3. ADJUST SLIDING ROOF GLASS IN UPWARD OR DOWNWARD DIRECTIONS
a. Loosen the screws shown in the illustration.
b. Adjust the sliding roof glass upward or downward.
4. ADJUST SLIDING ROOF GLASS IN CLEARANCE
(Difference in left and right clearance)
a. When the front or rear alignment is not correct, remove the drive gear and sliding roof glass, then adjust the drive cable.
NOTE: Remove the drive gear with the sliding roof fully closed.
b. Adjust by sliding the cable forward or rearward to align the 2 marks as shown.
c. Install the drive gear and sliding roof glass.
1. REMOVE SIDE GARNISH
Before making adjustment, using a screwdriver, remove the side garnishes.
HINT:
- Tape the screwdriver tip before use.
- After adjustment, reinstall the side garnishes.
2. ADJUST SLIDING ROOF GLASS FORWARD/REARWARD AND LEFT/RIGHT DIRECTIONS
a. Loosen the sliding roof glass installation nuts.
b. Adjust the sliding roof glass forward/rearward or left/right.
3. ADJUST SLIDING ROOF GLASS IN UPWARD OR DOWNWARD DIRECTIONS
a. Loosen the screws shown in the illustration.
b. Adjust the sliding roof glass upward or downward.
4. ADJUST SLIDING ROOF GLASS IN CLEARANCE
(Difference in left and right clearance)
a. When the front or rear alignment is not correct, remove the drive gear and sliding roof glass, then adjust the drive cable.
NOTE: Remove the drive gear with the sliding roof fully closed.
b. Adjust by sliding the cable forward or rearward to align the 2 marks as shown.
c. Install the drive gear and sliding roof glass.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.