Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
HINT:
If there is not the hand-held tester, begin with STEP 2.
- Perform active test.
PREPARATION:
- Connect the hand-held tester to the DLC3.
- Turn ignition switch ON and hand-held tester main switch ON.
- Select the ACTIVE TEST mode on the hand-held tester.
CHECK:
Check that light turns ON or OFF as the hand-held tester directs.
HINT:
All lights flush except shift indicator.
OK:
The light operates normally.
- OK: Proceed to next circuit inspection shown in problem symptoms table (See PROBLEM SYMPTOMS TABLE ).
- NG: Go to Next Step.
- Check bulb.
CHECK:
Apply the tester as shown to test for continuity.
OK:
Continuity
- NG: Replace bulb.
- OK: Go to Next Step.
- Check circuit plate. (See
INSPECTION
)
- NG: Replace circuit plate.
- OK: Go to next step.
Check and replace combination meter (See CIRCUIT ).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.