2003 Lexus ES 300FACTORY OEM SERVICE PROCEDURE

Problem Symptoms Table

PROBLEM SYMPTOMS

Symptom Suspected Area See page
Power seat does not operate 1. Front power seat switch INSPECTION 
2. PWR SEAT fuse -
3. Wire harness -
Power seat does not slide 1. Front power seat switch INSPECTION 
2. Front slide power seat motor assy (Slide) INSPECTION 
3. Wire harness -
Front vertical of the power seat does not operate (Driver's seat only) 1. Front power seat switch INSPECTION 
2. Front up, down power seat motor assy (Front vertical) INSPECTION 
3. Wire harness -
Rear lifter of the power seat does not operate (Driver's seat only) 1. Front power seat switch INSPECTION 
2. Power seat motor assy (Rear vertical) INSPECTION 
3. Wire harness -
Power seat does not recline 1. Front power seat switch INSPECTION 
2. Power seat motor assy (Reclining) INSPECTION 
3. Wire harness -
Lumber support does not operate (Driver's seat only) 1. Front power seat switch INSPECTION 
2. Power seat motor assy (Lumber support) INSPECTION 
3. Wire harness -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.