Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Moon Roof Switch
Inspect the moon roof switch continuity. See CONNECTOR IDENTIFICATION . See INSPECTING MOON ROOF SWITCH CONTINUITY table. If continuity is not as specified, replace the switch located on the overhead console box. See step 20 of ROOF HEADLINING under REMOVAL & INSTALLATION.
| Switch Position | Tester Connection | Specified Condition |
|---|---|---|
| SLIDE OPEN | 3 - 5 | Continuity |
| SLIDE OFF | ..... | No Continuity |
| SLIDE CLOSE | 3 - 4 | Continuity |
| TILT DOWN | 2 - 3 | Continuity |
| TILT OFF | ..... | No Continuity |
| TILT UP | 1 - 3 | Continuity |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.