Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wiper & Washer Switch (Rear) Circuit
Disconnect the connector from the motor and inspect the connector on the wiring harness side. See CONNECTOR IDENTIFICATION . See INSPECTING REAR WIPER & WASHER SWITCH CIRCUIT table. If circuit is not as specified, inspect the circuits connected to other parts.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - Ground | Constant | Continuity |
| 12 - Ground | Constant | B+ Voltage |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.