Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus LX 470FACTORY OEM SERVICE PROCEDURE
Yaw Rate Sensor
- Turn ignition off. Remove ABS/BA/TRAC/VSC ECU, located behind left side of dash. Do not disconnect harness connectors. Using a DVOM, check continuity between yaw rate sensor harness connector terminal No. 4 (Blue wire) and ABS/BA/TRAC/VSC ECU harness connector A43 terminal No. 19 (Blue wire). See WIRING DIAGRAMSΒ . If continuity does not exist, repair circuit as necessary. If continuity exists, go to next step.
- Backprobe DVOM positive lead to ABS/BA/TRAC/VSC ECU harness connector A43 terminal No. 19 (Blue wire) and negative lead to ECU harness connector A41 terminal No. 31 (White/Black wire). Turn ignition on. If voltage reading is 4.5-5.3 volts, replace ABS/BA/TRAC/VSC ECU. If voltage reading is not 4.5-5.3 volts, replace yaw rate sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
