Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Lexus LX 470FACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System/Vehicle Skid Control
- Description & Operation
- Bleeding Brake System
- Troubleshooting
- Diagnosis & Testing
- Diagnostic Tests
- Notes
- Abs DTCS C0278 / 11 & C0279 / 12: Abs Solenoid Relay Circuit
- Abs DTCS C0226 / 21, C0236 / 22, C0246 / 23 & C0256 / 24: Abs Solenoid Circuit
- Abs DTCS C1225 / 25, C1226 / 26, C1227 / 27 & C1228 / 28: TRAC & VSC Solenoid Circuit
- Abs DTC C0200 / 31, C0205 /32, C0210 /33 & C0215 /34: Speed Sensor Circuit
- Abs DTC C1237 / 37: Tires Of Different Size
- Abs DTC C1241 / 41: Low Battery Voltage Or Abnormally High Battery Positive Voltage
- Abs DTC C1242 / 42: Open IG2 Circuit
- Abs DTCS C1243 / 43 & C1245 / 45: Deceleration Sensor Malfunction
- Abs DTC C1244 / 44: Deceleration Sensor Circuit - Open/Short
- Abs DTC C1246 / 46: Malfunction In Master Cylinder Pressure Sensor
- Abs DTC C1249 / 49: Stoplight Switch Circuit
- Abs DTC C1251 / 51: Hydraulic Brake Booster Pump Motor Malfunction
- Abs DTC C1252 / 52: Hydraulic Brake Booster Pump Motor Run Time Abnormally Long
- Abs DTC C1253 / 53: Abs Motor Relay Circuit
- Abs DTC C1254 / 54: Pressure Switch Malfunction
- Abs DTC C1256 / 56: Accumulator Low Pressure Malfunction
- Abs DTC C1257 / 57: Power Supply Drive Circuit Malfunction
- Abs DTC C1268 / 68: Transfer L4 Position Switch Circuit
- Abs DTC C1269 / 69: PNP Switch Circuit ("R" Position)
- VSC DTC 31: Steering Angle Sensor Circuit
- VSC DTC 32: Deceleration Sensor Circuit
- VSC DTC 33 Or 34: Yaw Rate Sensor Circuit
- VSC DTC 36: Yaw Rate Sensor Calibration
- VSC DTC 37: PNP Switch Circuit ("P" & "R" Position)
- VSC DTC 39: Deceleration Sensor Calibration
- VSC DTC 43: Abs Control System Malfunction
- VSC DTC 44: Ne Signal Circuit
- VSC DTC 47: Center Differential Lock Circuit
- VSC DTC 51: Engine Control System Malfunction
- VSC DTC 53: ECM Communication Circuit Malfunction
- Abs Warning Light Always On (Ecu Malfunction)
- VSC TRAC Warning Light Circuit (Ecu Malfunction)
- Circuit Tests
- Component Testing
- Removal & Installation
- Overhaul
- Adjustments
- Torque Specifications
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
