Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Injector Volume
1998 Lexus SC 300SECTION Fuel Injector Volume
- On ES300, remove fuel injector. See REMOVE/INSTALL/OVERHAUL article. Connect Fuel Tube Adapter (23801-20040) to fuel filter outlet side. Ensure fuel injector "O" ring is installed. Install Injection Measuring Tool Set (09268-41046). See Fig 1 or Fig 2. Install injector retainer clip. Attach a piece of vinyl tubing to bottom of fuel injector to prevent fuel splash. Put vinyl tubing into a graduated measuring cylinder. Go to step 4).
- On GS300, SC300 and GS400, remove fuel injector. See REMOVE/INSTALL/OVERHAUL article. Disconnect fuel inlet hose from main tube. Install Fuel Tube Adapter (09268-52011) to fuel main tube. Ensure fuel injector "O" ring is installed. Install Injection Measuring Tool Set (09268-41047). See Fig 1 or Fig 2. Install injector retainer clip. Attach a piece of vinyl tubing to bottom of fuel injector to prevent fuel splash. Put vinyl tubing into a graduated measuring cylinder. Go to step 4).
- On SC400, remove fuel injector. See REMOVE/INSTALL/OVERHAUL article. Disconnect fuel inlet hose from main tube. Install Fuel Tube Adapter (09631-22020) to fuel main tube. Ensure fuel injector "O" ring is installed. Install Injection Measuring Tool Set (09268-41047). See Fig 1 or Fig 2. Install injector retainer clip. Attach a piece of vinyl tubing to bottom of fuel injector to prevent fuel splash. Put vinyl tubing into a graduated measuring cylinder. Go to next step.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.