Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2ND Brake: Reassembly
Coat NEW "O" rings with ATF and install. Carefully press 2nd brake piston into 2nd brake drum. Install piston return spring and spring retainer. See Fig 1. Compress return spring and install snap ring. Apply compressed air to 2nd brake drum. Ensure 2nd brake piston moves smoothly. Install thrust washer. Ensure cutout portions of thrust washer match teeth of spring retainer.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.