2011 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (Pcm) Short Drive Cycle Self-Test

NOTE: This procedure is an overcheck only. If fault codes are found, interrogation of the relevant system must be carried out and claimed against.
  1. Connect the diagnostic equipment to the vehicle.
  2. Follow on screen prompts and check for engine management fault codes.
  3. Clear the fault codes following the on screen procedure.
  4. Start the engine.
    • Allow the engine to idle for 30 seconds.
    • Raise the engine speed to 1500 rpm and hold for 3 minutes until a temperature of 70°C (158 °F) is achieved.
    • Allow the engine to idle for 30 seconds.
    • Switch off the engine.
    5. NOTE: If fault codes are found, interrogation of the relevant system must be carried out and claimed against.
  5. Follow on screen prompts and check for engine management fault codes.
  6. Disconnect the diagnostic equipment from the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.