Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLAND ROVER2009LR3 (LA) V8-4.4LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIR
2009 Land Rover LR3 (LA) V8-4.4L
Ignition Switch: Service and Repair
2009 Land Rover LR3 (LA) V8-4.4LSECTION Service and Repair
Ignition Switch
Service Repair No - 86.65.02
Removal
1. Fully extend the steering column for access.
2. Remove the steering column upper shroud.
^ Release the 4 clips.
3. Remove the steering column lower shroud.
^ Remove the 3 Torx screws.
^ Release the steering column adjustment lever.
4. CAUTION: The ignition key must be removed prior to the removal of the ignition switch.
Remove the ignition switch. Disconnect the electrical connector. Depress the 2 clips.
Installation
1. Install the ignition switch.
^ Secure with the clips.
^ Connect the electrical connector.
2. Install the steering column shrouds.
^ Tighten the Torx screws.
^ Secure the clips.
^ Secure the adjustment lever.
Service Repair No - 86.65.02
Removal
1. Fully extend the steering column for access.
2. Remove the steering column upper shroud.
^ Release the 4 clips.
3. Remove the steering column lower shroud.
^ Remove the 3 Torx screws.
^ Release the steering column adjustment lever.
4. CAUTION: The ignition key must be removed prior to the removal of the ignition switch.
Remove the ignition switch. Disconnect the electrical connector. Depress the 2 clips.
Installation
1. Install the ignition switch.
^ Secure with the clips.
^ Connect the electrical connector.
2. Install the steering column shrouds.
^ Tighten the Torx screws.
^ Secure the clips.
^ Secure the adjustment lever.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.