Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLAND ROVER2009LR3 (LA) V8-4.4LREPAIR AND DIAGNOSISBODY AND FRAMEROOF AND ASSOCIATED COMPONENTSSUNROOF / MOONROOFADJUSTMENTS
2009 Land Rover LR3 (LA) V8-4.4L
Sunroof / Moonroof: Adjustments
2009 Land Rover LR3 (LA) V8-4.4LSECTION Adjustments
Roof Opening Panel Alignment
Service Repair No - 76.84.82
1. With the roof opening panel closed, check the alignment of the glass to the roof panel. The glass should be central in its aperture. Profile of sunroof to body:
^ Front edge, set flush or up to 1.0 mm (0.040' ) low.
^ Rear edge, set flush or up to 1.0 mm (0.040' ) high.
2. Open the roof opening panel blind.
3. Loosen the 6 roof opening panel Torx bolts.
4. Align the roof opening panel.
^ Tighten the Torx screws to 6 Nm (4 lb.ft).
5. Close the roof opening panel blind.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.