Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLAND ROVER2008RANGE ROVER (LM) V8-4.2L SCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - LIGHTING AND HORNSTRAILER LIGHTING MODULESERVICE AND REPAIR
2008 Land Rover Range Rover (LM) V8-4.2L SC
Trailer Lighting Module: Service and Repair
2008 Land Rover Range Rover (LM) V8-4.2L SCSECTION Service and Repair
Trailer Module
Removal
1. Disconnect the battery ground cable.
^ If the trailer module is to be replaced, use the approved Land Rover diagnostic equipment and follow the on-screen instructions prior to battery disconnection.
2. Remove the access panel from the loadspace trim panel RH.
3. Release the trailer module.
^ Remove the 2 nuts.
4. Remove the trailer module.
^ Disconnect the electrical connector.
Installation
1. Install the trailer module.
^ Connect the electrical connector.
2. Secure the trailer module.
^ Install the nuts.
3. Install the access panel to the loadspace trim panel RH.
4. Connect the battery ground cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.