Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLAND ROVER2008RANGE ROVER (LM) V8-4.2L SCREPAIR AND DIAGNOSISBODY AND FRAMEINTERIOR MOULDING / TRIMGLOVE COMPARTMENTSERVICE AND REPAIRFLOOR CONSOLE STOWAGE COMPARTMENT
2008 Land Rover Range Rover (LM) V8-4.2L SC
Floor Console Stowage Compartment
2008 Land Rover Range Rover (LM) V8-4.2L SCSECTION Floor Console Stowage Compartment
Floor Console Stowage Compartment
Removal
1. Remove the floor console stowage compartment.
^ Open the floor console stowage compartment lid.
^ Remove the 2 screws.
^ Using a suitable tool, carefully release the 2 clips.
^ Disconnect the cigar lighter electrical connector.
NOTE: Do not disassemble further if the component is removed for access only.
2. Remove the cigar lighter assembly.
^ Remove the cigar lighter.
^ With extreme care release the 2 clips and remove the cigar lighter inner housing.
^ Remove the cigar lighter housing.
Installation
1. Install the cigar lighter assembly.
CAUTION: Make sure the locating tangs are aligned.
2. Install the floor console stowage compartment.
^ Connect the cigar lighter electrical connector.
^ Secure the 2 clips.
^ Install the 2 screws.
^ Close the floor console stowage compartment lid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.