Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Procedures: Check
- Ensure tire pressures are correct and vehicle is at curbside weight and on a level surface.
- Release hand brake.
- Roll vehicle backwards and forwards to relieve stresses in steering/front suspension.
- Check that front wheel alignment is within tolerance. See WHEEL ALIGNMENT SPECIFICATIONSΒ .
NOTE:
Ensure that alignment equipment is properly calibrated. Take an average of three readings. Use recommended equipment only.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
