2002 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

NOTE: Check at curb weight.
WHEEL ALIGNMENT SPECIFICATIONS

Application (1)Specification
Range Rover
(2)Camber 0Β°
(2)Caster 4Β°
Toe-Out Measurement 0.6 to 1.80 mm (0.02-0.07")
Toe-Out Included Angle 0Β°5' to 0Β°15'
Swivel Pin Inclination Static 8Β°
Steering Wheel Diameter 406.4 mm (16")
(1) Check at curb weight.
(2) Camber and caster are not adjustable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.